Subject	Yes provided you set the voltage to the specified amount >>
Posted by	ZUL8TR on August 23, 2012 at 1:11 PM
	This message has been viewed 194 times.
In Reply To	Re: Check and adjust the TPS using the pin probe method> posted by slcZ32 on August 23, 2012 at 12:15 PM
Message	by loosening the two secure bolts and rotating the TPS in the correct direction that will be obvious by watching the digital volt reading on the VOM. Set it at 0.45v. It will move somewhat when you tighten the bolts so allow for this after fully tight. Don't forget the unplug the gray connector routine. If you need further instruction on setting the pins in the correct wires let me know. It takes a bit of probing to get the pins to contact. Also it will help if you have alligator clips on the VOM probes. The readings are taken with the key in the ON position just before the start position. ZUL8TR in Orlando,FL
Follow Ups	1990 NA idling issues, please help - slcZ32 23:45:22 08/22/12 Have you checked for codes? - JonnyZ(SoCal) 00:10:52 08/23/12 Re: Have you checked for codes? - slcZ32 00:40:32 08/23/12 forgot to meantion - slcZ32 01:00:41 08/23/12 Re: forgot to meantion - Medallion Man 02:37:47 08/23/12 Check and adjust the TPS using the pin probe method> - ZUL8TR 09:57:04 08/23/12 Re: Check and adjust the TPS using the pin probe method> - slcZ32 12:15:01 08/23/12 Yes provided you set the voltage to the specified amount >> - ZUL8TR 13:11:29 08/23/12 follow up on resetting IACV and TPS - slcZ32 02:38:46 08/24/12 Re: follow up on resetting IACV and TPS - Medallion Man 03:31:51 08/24/12 Re: Re: follow up on resetting IACV and TPS - slcZ32 14:26:55 08/24/12 Re: Re: Re: follow up on resetting IACV and TPS - Medallion Man 02:15:20 08/25/12
Post a Followup	You cannot reply to this message because you are not logged in.