Subject	Re: Why the 4400rpm limit?
Posted by	zromtech_ on June 05, 2012 at 10:52 PM
	This message has been viewed 817 times.
In Reply To	Why the 4400rpm limit? posted by beanz on June 05, 2012 at 02:56 PM
Message	The knock detection code in the ECU can detect knock between 1200 and 4400rpm. The benefits to increasing the knock zone really depend on how you want your tune to behave, although the obvious advantage would be the additional safety factor.
Follow Ups	Knock Sensor / Detonation Sensor: How it Works & How to Test - OverZealous (CT) 00:11:01 06/05/12 Re: Knock Sensor / Detonation Sensor: How it Works & How to Test - Android300zx 09:45:44 06/05/12 Thanks! Good write up... - beanz 11:58:02 06/05/12 Re: Thanks! Good write up... - zromtech 13:01:14 06/05/12 Are you going to market the software you are working on? (n/m) - Evan_Wright (Ca) 14:20:26 06/05/12 Re: Are you going to market the software you are working on? - zromtech_ 22:07:49 06/05/12 Why the 4400rpm limit? - beanz 14:56:02 06/05/12 It is certainly possible to detonate above 4400 rpm - OverZealous (CT) 22:11:09 06/05/12 Re: Why the 4400rpm limit? - zromtech_ 22:52:45 06/05/12 Very informative - RobZ32 12:27:40 06/05/12 Good Layout, understandable presentation. Thank You. (n/m) - Gordo 93TT Daytona 12:49:33 06/05/12 Any comment on knock sensor relocation (n/m) - ZiNnYc 19:25:21 06/05/12 It's a great temporary solution -- fuzzymonkey squeak up! - OverZealous (CT) 22:01:55 06/05/12 From the picture included -- did you end up installing - jzack 23:20:15 06/05/12 Yes, I attached just a single wire. 2-wire set up = overkill - OverZealous (CT) 14:28:18 06/06/12 Or where it is located so buried and surrounded by metal - jzack 23:24:51 06/06/12 I believe the RF shielding is pretty important. See below. - OverZealous (CT) 21:45:11 06/07/12 Nice! I would like to clarify why only one side is grounded. - DVDBURN (MD) 23:20:40 06/06/12 Another link. - DVDBURN (MD) 23:42:53 06/06/12 Woah! So do NOT connect Terminal B to anything. - OverZealous (CT) 21:37:41 06/07/12
Post a Followup	You cannot reply to this message because you are not logged in.