Subject	Why the 4400rpm limit?
Posted by	beanz on June 05, 2012 at 2:56 PM
	This message has been viewed 796 times.
In Reply To	Re: Thanks! Good write up... posted by zromtech on June 05, 2012 at 01:01 PM
Message	And would it be substantially beneficial to raise the knock zone to higher a RPM, if possible? Are there likely to be conditions in which you might only be detonating over 4400rpm? Andy
Follow Ups	Knock Sensor / Detonation Sensor: How it Works & How to Test - OverZealous (CT) 00:11:01 06/05/12 Re: Knock Sensor / Detonation Sensor: How it Works & How to Test - Android300zx 09:45:44 06/05/12 Thanks! Good write up... - beanz 11:58:02 06/05/12 Re: Thanks! Good write up... - zromtech 13:01:14 06/05/12 Are you going to market the software you are working on? (n/m) - Evan_Wright (Ca) 14:20:26 06/05/12 Re: Are you going to market the software you are working on? - zromtech_ 22:07:49 06/05/12 Why the 4400rpm limit? - beanz 14:56:02 06/05/12 It is certainly possible to detonate above 4400 rpm - OverZealous (CT) 22:11:09 06/05/12 Re: Why the 4400rpm limit? - zromtech_ 22:52:45 06/05/12 Very informative - RobZ32 12:27:40 06/05/12 Good Layout, understandable presentation. Thank You. (n/m) - Gordo 93TT Daytona 12:49:33 06/05/12 Any comment on knock sensor relocation (n/m) - ZiNnYc 19:25:21 06/05/12 It's a great temporary solution -- fuzzymonkey squeak up! - OverZealous (CT) 22:01:55 06/05/12 From the picture included -- did you end up installing - jzack 23:20:15 06/05/12 Yes, I attached just a single wire. 2-wire set up = overkill - OverZealous (CT) 14:28:18 06/06/12 Or where it is located so buried and surrounded by metal - jzack 23:24:51 06/06/12 I believe the RF shielding is pretty important. See below. - OverZealous (CT) 21:45:11 06/07/12 Nice! I would like to clarify why only one side is grounded. - DVDBURN (MD) 23:20:40 06/06/12 Another link. - DVDBURN (MD) 23:42:53 06/06/12 Woah! So do NOT connect Terminal B to anything. - OverZealous (CT) 21:37:41 06/07/12
Post a Followup	You cannot reply to this message because you are not logged in.