Subject	Still trying to picture how a LOT of oil could work itself
Posted by	doug8867 on May 04, 2012 at 10:20 AM
	This message has been viewed 158 times.
In Reply To	The slave better not be dead. posted by rojoloco (VA Beach) on May 04, 2012 at 09:11 AM
Message	down the back side of your engine and then backwards to the slave. When my valve covers were leaking the oil went down the back side then collected on the turbos/downpipe area and would slowly drop a drip or two below there. Interesting. But if you replaced it several years ago having it rusting out would seem unlikely so soon, that's for sure. Guess I'd make sure the stainless steel line is tightly connected. Kinda out of suggestions at this point. :-)
Follow Ups	Clutch bleed fail - rojoloco (VA Beach) 14:49:09 04/29/12 Maybe the seal on the MC is shot and letting air in? - my91z 15:05:59 04/29/12 No leakage at all. - rojoloco (VA Beach) 15:23:23 04/29/12 One of the bleeders not holding tight and sucking air >> - my91z 15:37:49 04/29/12 I've had this bleeders problem too - OverZealous (CT) 16:27:41 04/29/12 Do you have a write-up? (n/m) - rojoloco (VA Beach) 18:49:21 04/29/12 Not a lot to it - install SB into the slave cylinder, - jzack 22:29:11 04/29/12 Gotcha. I've never used a SB. - rojoloco (VA Beach) 05:29:24 04/30/12 Cheap Siphon Reverse Bleed Setup - OverZealous (CT) 22:16:38 04/30/12 Thanks! I'll have to try this method. - rojoloco (VA Beach) 09:56:09 05/01/12 Did you get my email? (n/m) - my91z 16:16:45 05/01/12 If it was sent today, not yet. I replied to one this morning - rojoloco (VA Beach) 13:43:51 05/02/12 I've gotten good results using a speedbleeders bleeder (n/m) - AHos(Chicago) 18:54:45 04/29/12 If you can't even shift the car into gear there would - doug8867 21:00:03 05/01/12 I've gotten conflicting info on the clutch booster. - rojoloco (VA Beach) 13:47:00 05/02/12 Agree that booster is not likely to cause your - doug8867 15:13:54 05/02/12 I can try it. - rojoloco (VA Beach) 05:56:39 05/03/12 You had me at: - doug8867 08:20:34 05/03/12 That still leaves a few unanswered questions though. - rojoloco (VA Beach) 11:52:34 05/03/12 Not sure. I had times where I could shift like butter - doug8867 14:40:06 05/03/12 I checked for fluid at the firewall today. - rojoloco (VA Beach) 20:18:49 05/03/12 I would thoroughly clean you slave of wetness, then - doug8867 07:03:45 05/04/12 The slave better not be dead. - rojoloco (VA Beach) 09:11:13 05/04/12 Still trying to picture how a LOT of oil could work itself - doug8867 10:20:23 05/04/12 Now you can fully understand my confusion. - rojoloco (VA Beach) 10:33:13 05/04/12 The pedal adjustment didn't do squat. - rojoloco (VA Beach) 22:18:35 05/04/12 Did you clean your slave first and then inspect - doug8867 09:44:12 05/07/12 Yeah, I cleaned it first. - rojoloco (VA Beach) 08:32:05 05/09/12 Forgot to answer your question about rebuilding MC. - doug8867 11:44:13 05/03/12
Post a Followup	You cannot reply to this message because you are not logged in.