Subject	IF you can get them removed from the O2 sensor --
Posted by	jzack on September 11, 2011 at 5:16 PM
	This message has been viewed 242 times.
In Reply To	Re: - posted by jjamez on September 10, 2011 at 11:20 PM
Message	I put one in a massive vise and used a 4ft breaker bar and still couldn't get the two to separate (LOL). Perhaps submerging in a rust desolver solution for a few days would have done it? But since a new bung adapters is so cheap -- not sure it's worth the effort?
Follow Ups	o2 sensor replacement na - jjamez 17:16:40 09/10/11 I unclip them from up top, the get under the car and remove - Red Hawk (CO) 17:48:45 09/10/11 Re: o2 sensor replacement na - jjamez 17:50:15 09/10/11 I found them pretty easy to access via the top -- - jzack 22:47:35 09/10/11 Re: - - jjamez 23:20:51 09/10/11 IF you can get them removed from the O2 sensor -- - jzack 17:16:49 09/11/11 used a little pb blaster, and got mine apart. (n/m) - jjames69 14:00:07 09/12/11 Did that too as well as freezing spray, heat, torch , etc... (n/m) - jzack 19:16:59 09/12/11 OEM is Bosch (n/m) - na300zx (OH) 06:06:43 09/12/11 bosch(o reilly)$180, dealer $250 (n/m) - jjames69 14:05:58 09/12/11 is there only 2 sensors? - jjamez 18:20:51 09/10/11
Post a Followup	You cannot reply to this message because you are not logged in.