Subject	I went ahead and ordered the Snap-On retainer tool >>
Posted by	my91z on July 05, 2011 at 6:51 PM
	This message has been viewed 599 times.
In Reply To	Would think if it's hitting the piston -- there's no drop posted by jzack on July 05, 2011 at 06:33 PM
Message	Amazon seal pulling pliers I linked to, and the viton valve seals from Z1. Will post an update with how things work out and what I did in a week or so hopefully. Mike --------------------------------------------------------
Follow Ups	Anyone replaced valve stem seals w/ heads on the engine? - my91z 12:49:53 07/04/11 Replace valve stem seals w/ heads on the engine. - gbhrps 15:33:02 07/04/11 I could, and I have a compression testing hose I could use > - my91z 16:19:52 07/04/11 What's wrong with just having the piston up at TDC? Since - jzack 18:36:16 07/04/11 Not concerned about the valve hitting the piston >> - my91z 18:57:50 07/04/11 Would think if it's hitting the piston -- there's no drop - jzack 18:33:26 07/05/11 I went ahead and ordered the Snap-On retainer tool >> - my91z 18:51:58 07/05/11 A Z-friend of did it, using a self-made tool : - Dark Diver 15:54:13 07/04/11 Re: A Z-friend of did it, using a self-made tool : - jaidieray 16:14:53 07/04/11 So it's long enough to reach down into the head OK? - my91z 16:26:42 07/04/11 I used air when changing my valve springs, no problems. (n/m) - ae300z 19:57:28 07/04/11 Thanks for the pics. Did he need to fabricate the tool, or > - my91z 16:21:42 07/04/11 Re: A Z-friend of did it, using a self-made tool : - WazTTed 03:43:54 07/06/11 I assume you are asking me? It didn't affect anything as far - my91z 06:25:12 07/06/11
Post a Followup	You cannot reply to this message because you are not logged in.