Subject	So it's long enough to reach down into the head OK?
Posted by	my91z on July 04, 2011 at 4:26 PM
	This message has been viewed 498 times.
In Reply To	Re: A Z-friend of did it, using a self-made tool : posted by jaidieray on July 04, 2011 at 04:14 PM
Message	Only $10 more for a Snap-On tool isn't bad, as long as it isn't just a rebadged version of the Amazon tool Ilinked to. What did you use to pull the old seals off? Did you use air in the cylinders or rope to hold the valves up? Thanks, Mike --------------------------------------------------------
Follow Ups	Anyone replaced valve stem seals w/ heads on the engine? - my91z 12:49:53 07/04/11 Replace valve stem seals w/ heads on the engine. - gbhrps 15:33:02 07/04/11 I could, and I have a compression testing hose I could use > - my91z 16:19:52 07/04/11 What's wrong with just having the piston up at TDC? Since - jzack 18:36:16 07/04/11 Not concerned about the valve hitting the piston >> - my91z 18:57:50 07/04/11 Would think if it's hitting the piston -- there's no drop - jzack 18:33:26 07/05/11 I went ahead and ordered the Snap-On retainer tool >> - my91z 18:51:58 07/05/11 A Z-friend of did it, using a self-made tool : - Dark Diver 15:54:13 07/04/11 Re: A Z-friend of did it, using a self-made tool : - jaidieray 16:14:53 07/04/11 So it's long enough to reach down into the head OK? - my91z 16:26:42 07/04/11 I used air when changing my valve springs, no problems. (n/m) - ae300z 19:57:28 07/04/11 Thanks for the pics. Did he need to fabricate the tool, or > - my91z 16:21:42 07/04/11 Re: A Z-friend of did it, using a self-made tool : - WazTTed 03:43:54 07/06/11 I assume you are asking me? It didn't affect anything as far - my91z 06:25:12 07/06/11
Post a Followup	You cannot reply to this message because you are not logged in.