Subject	Re: Z1 GT675RS clearance issue . does the turbo need to be
Posted by	txq45 on February 25, 2011 at 12:38 PM
	This message has been viewed 217 times.
In Reply To	Z1 GT675RS clearance issue . does the turbo need to be posted by xteam300tt on February 25, 2011 at 11:59 AM
Message	I have the Garrett Gt 2860rs (same as Z1 Gt675) except they have the inlet modified to accept the inlet for the Z32 from Z1 whereas I modified the inlet flange to accept the bolt pattern on the compressor.. From the picture I would try to clock the compressor housing to the Left unless the outlet came tooo close to the plenum Nistune Dealer Parts www.aaa-hiperformanceauto.com ECU socketing ECU eprom upgrade
Follow Ups	Z1 GT675RS clearance issue . does the turbo need to be - xteam300tt 11:59:42 02/25/11 sorry im refering to the inlet pipe not clearing the - xteam300tt 12:02:22 02/25/11 Re: Z1 GT675RS clearance issue . does the turbo need to be - txq45 12:38:28 02/25/11 I ground my mount when I installed my 675's (n/m) - Hoppy2 15:52:09 02/25/11 I've had this issue with a lot of the turbos I've installed - Brett@AwesomeZ 16:05:56 02/25/11 Re: I ground my mount when I installed my 675's - txq45 17:27:57 02/25/11 Re: Z1 GT675RS clearance issue . does the turbo need to be - WazTTed 18:08:42 02/25/11 Re: Just grind down the MM a little - ba11erz 20:40:48 02/25/11 grind it or get BDEs (n/m) - ZiNnYc 17:21:49 02/26/11
Post a Followup	You cannot reply to this message because you are not logged in.