Subject	you need to unscrew the bearing from the rod and push the
Posted by	Ziceman(East TN) on January 31, 2011 at 10:58 AM
	This message has been viewed 139 times.
In Reply To	quick question posted by Nis300owner on January 30, 2011 at 01:30 PM
Message	threaded end through one of the two side holes of the boot. Then push the threaded end down and out the bottom of the boot. It will streach over the bearing.
Follow Ups	quick question - Nis300owner 13:30:24 01/30/11 They weren't pre-installed? - KongZTT GT28RS MD 13:48:27 01/30/11 nope all that money and not all together. Ive tryed lube - Nis300owner 13:59:59 01/30/11 I have the old style SPL tension rods and it has no dust - KongZTT GT28RS MD 14:22:35 01/30/11 not yet have to do it first thing tomorrow with it being - Nis300owner 14:28:54 01/30/11 you need to unscrew the bearing from the rod and push the - Ziceman(East TN) 10:58:15 01/31/11 ... - KongZTT GT28RS MD 11:07:29 01/31/11 it just takes a little persuasion - youngbloodz 20:15:38 02/01/11
Post a Followup	You cannot reply to this message because you are not logged in.