Subject	You could remove the Alum. bushings and grind them down
Posted by	Turnerscasa (Dallas) on May 23, 2010 at 6:19 AM
	This message has been viewed 133 times.
In Reply To	Powertrix Upper A-Arms posted by LoqueZX(CA) on May 22, 2010 at 05:56 PM
Message	to fit. In your case the black ones on each end that are preventing you from mounting your FUCA's. I had the same challange, (not Powertrix) and ground down the bushing on each side until they fit. Installed nice after that. Current "Z" 1994 300ZX TT 5,Speed (Pearl) 2007 G35S Sedan (Garnet) Past "Z cars" 2003 G35 Sedan (White) 1991 300ZX TT 5, Speed (Red) 1990 300ZX 5, Speed NA (Red)
Follow Ups	Powertrix Upper A-Arms - LoqueZX(CA) 17:56:44 05/22/10 The bracket may need to be spread. Shouldn't take much. (n/m) - Wright (Ca) 20:11:05 05/22/10 How did you spread it? - LoqueZX(CA) 22:17:10 05/22/10 pliers no, "Spreader", yes. Ask Powertrix to make sure (n/m) - CoHPhasor 22:30:41 05/22/10 And easy way is to take a piece of all thread 3 nuts - vigman 14:02:15 05/24/10 I wonder if you could use a piece of - zellamay 01:57:11 05/23/10 You could remove the Alum. bushings and grind them down - Turnerscasa (Dallas) 06:19:21 05/23/10 just take two vice grips to widen it. (n/m) - SuparexTT 15:19:52 05/24/10
Post a Followup	You cannot reply to this message because you are not logged in.