Subject	How did you spread it?
Posted by	LoqueZX(CA) on May 22, 2010 at 10:17 PM
	This message has been viewed 104 times.
In Reply To	The bracket may need to be spread. Shouldn't take much. (n/m) posted by Wright (Ca) on May 22, 2010 at 08:11 PM
Message	The metal is pretty thick. I had tried that with a couple pair of pliers.
Follow Ups	Powertrix Upper A-Arms - LoqueZX(CA) 17:56:44 05/22/10 The bracket may need to be spread. Shouldn't take much. (n/m) - Wright (Ca) 20:11:05 05/22/10 How did you spread it? - LoqueZX(CA) 22:17:10 05/22/10 pliers no, "Spreader", yes. Ask Powertrix to make sure (n/m) - CoHPhasor 22:30:41 05/22/10 And easy way is to take a piece of all thread 3 nuts - vigman 14:02:15 05/24/10 I wonder if you could use a piece of - zellamay 01:57:11 05/23/10 You could remove the Alum. bushings and grind them down - Turnerscasa (Dallas) 06:19:21 05/23/10 just take two vice grips to widen it. (n/m) - SuparexTT 15:19:52 05/24/10
Post a Followup	You cannot reply to this message because you are not logged in.