Subject	I think that the motor is slanted back a little bit. Once
Posted by	ZTicket(Dallas) on May 17, 2010 at 10:27 PM
	This message has been viewed 257 times.
In Reply To	question posted by KasbeKZ(VA) on May 17, 2010 at 06:10 PM
Message	the tranny was stabbed and bolted up, the rear of the transmission had to be jacked up about 3 inches to meet with the attach points. If you're jackin' the transmission up in the back and it's attached to the motor in the front...well, I say the whole engine/transmission is leaning back.
Follow Ups	Successful single-handed transmission stabbing. Determined - ZTicket(Dallas) 09:52:17 05/17/10 thats the way to do it - aliaZ 10:24:08 05/17/10 Re: Successful single-handed transmission stabbing. Determined - txq45 11:01:29 05/17/10 question - KasbeKZ(VA) 18:10:17 05/17/10 I think that the motor is slanted back a little bit. Once - ZTicket(Dallas) 22:27:32 05/17/10 I'll never do another trans pull without a jack - Rocket man 19:35:52 05/17/10 Next time I re-install the trans I'll try this method - TTFairladyZ 17:32:03 05/18/10 Re: Successful single-handed transmission stabbing. Determined - CmyZ 17:34:09 05/19/10 Where does the lithium grease go? (n/m) - jzack 22:23:43 05/19/10 Good job...IMO it shouldn't be called stabbing - Ashman2k2 10:48:09 05/21/10
Post a Followup	You cannot reply to this message because you are not logged in.