Subject	question
Posted by	KasbeKZ(VA) on May 17, 2010 at 6:10 PM
	This message has been viewed 215 times.
In Reply To	Successful single-handed transmission stabbing. Determined posted by ZTicket(Dallas) on May 17, 2010 at 09:52 AM
Message	can it be stabbed if it's perfectly in line with how it will sit? does it need to be tilted when it gets stabbed? i have always thought it needed to be tilted, but if you're using 4 guide bolts, i don't think it would be able to be tilted during the initial penetration.
Follow Ups	Successful single-handed transmission stabbing. Determined - ZTicket(Dallas) 09:52:17 05/17/10 thats the way to do it - aliaZ 10:24:08 05/17/10 Re: Successful single-handed transmission stabbing. Determined - txq45 11:01:29 05/17/10 question - KasbeKZ(VA) 18:10:17 05/17/10 I think that the motor is slanted back a little bit. Once - ZTicket(Dallas) 22:27:32 05/17/10 I'll never do another trans pull without a jack - Rocket man 19:35:52 05/17/10 Next time I re-install the trans I'll try this method - TTFairladyZ 17:32:03 05/18/10 Re: Successful single-handed transmission stabbing. Determined - CmyZ 17:34:09 05/19/10 Where does the lithium grease go? (n/m) - jzack 22:23:43 05/19/10 Good job...IMO it shouldn't be called stabbing - Ashman2k2 10:48:09 05/21/10
Post a Followup	You cannot reply to this message because you are not logged in.