Subject	Sounds like yet another adjustment issue.
Posted by	Spddracer on May 17, 2010 at 12:49 PM
	This message has been viewed 244 times.
In Reply To	clutch pedal loses pressure after 20 mins of driving posted by surfer31337 on May 16, 2010 at 01:59 AM
Message	Pedal adjustment too tight will cause your issue. Back off the adjustment a little bit and see what it does. Thread rod into the clevis .5-1.0 turns and try it again. Noise from the clutch is not normal and the installer should have never greased the throw out bearing, It will sling out and can get on the clutch itself. They come pregreased and there is no need to regrease the TOB. Clicking noise when you push the clutch could be the Throw out bearing installed wrong on the fork, faulty pressure plate, Worn throw out bearing guide on the front cover ect. Most likely installer error. www.Zspeedperformance.com
Follow Ups	clutch pedal loses pressure after 20 mins of driving - surfer31337 01:59:29 05/16/10 forgot to mention... no leaks and clutch fluid remains full (n/m) - surfer31337 02:04:22 05/16/10 Did he bleed the fitting on the passenger side of - ShakaShaun(Denver) 02:37:32 05/16/10 yes, bled slave first, then the passenger engine bay (n/m) - surfer31337 02:45:42 05/16/10 Re: yes, bled slave first, then the passenger engine bay - Marty1Mc 06:48:18 05/16/10 2nd on air in the line -- what you've describe is what - jzack 09:10:36 05/16/10 Sounds like yet another adjustment issue. - Spddracer 12:49:26 05/17/10 thanx for your insight. tomorrow i will adjust the pedal - surfer31337 01:32:58 05/18/10 Just delete the bleed point up by the pwr steering reservoir - LJZTT 13:06:06 05/18/10
Post a Followup	You cannot reply to this message because you are not logged in.