Subject	very strange. i'll investigate further.
Posted by	KasbeKZ(VA) on May 14, 2010 at 6:52 AM
	This message has been viewed 71 times.
In Reply To	Hmm, stock it doesn't connect to the exhaust manifold. (n/m) posted by Woody75 (Denver) on May 13, 2010 at 03:26 PM
Message	i could have hooked it back up wrong when i had the heads off though, so where does the end of that line go stock?
Follow Ups	another ground question - KasbeKZ(VA) 19:07:15 05/11/10 That go's to trans bellhousing bolt (n/m) - njz 19:36:52 05/11/10 oh... so that hasn't been hooked up for a while... - KasbeKZ(VA) 19:58:16 05/11/10 Did it still start with it disconnected? (n/m) - Draker (Eugene, OR) 20:25:37 05/11/10 if it actually hooks to a bell housing bolt, then yeah - KasbeKZ(VA) 05:46:48 05/12/10 Wow, well that's cool. - Draker (Eugene, OR) 17:02:05 05/12/10 so, nobody contesting? - KasbeKZ(VA) 16:51:35 05/12/10 It does go to the bell housing for sure. (n/m) - Draker (Eugene, OR) 17:02:33 05/12/10 ok. i just got out there and looked around - KasbeKZ(VA) 17:44:19 05/12/10 yeah nm. i'm sure that's it (n/m) - KasbeKZ(VA) 18:51:29 05/12/10 It's goes on the top tranny bolt, 1 o'clock position. - Woody75 (Denver) 08:42:02 05/13/10 past that loop, in the picture, the wire continues - KasbeKZ(VA) 11:02:27 05/13/10 Hmm, stock it doesn't connect to the exhaust manifold. (n/m) - Woody75 (Denver) 15:26:55 05/13/10 very strange. i'll investigate further. - KasbeKZ(VA) 06:52:11 05/14/10
Post a Followup	You cannot reply to this message because you are not logged in.