Subject	past that loop, in the picture, the wire continues
Posted by	KasbeKZ(VA) on May 13, 2010 at 11:02 AM
	This message has been viewed 65 times.
In Reply To	It's goes on the top tranny bolt, 1 o'clock position. posted by Woody75 (Denver) on May 13, 2010 at 08:42 AM
Message	and ends with a loop like the one pictured on an exhaust manifold stud. thanks for the response. i got some new bell housing bolts with my last order, so i'll get under there and fix it all up once it's running well enough to get up on ramps!
Follow Ups	another ground question - KasbeKZ(VA) 19:07:15 05/11/10 That go's to trans bellhousing bolt (n/m) - njz 19:36:52 05/11/10 oh... so that hasn't been hooked up for a while... - KasbeKZ(VA) 19:58:16 05/11/10 Did it still start with it disconnected? (n/m) - Draker (Eugene, OR) 20:25:37 05/11/10 if it actually hooks to a bell housing bolt, then yeah - KasbeKZ(VA) 05:46:48 05/12/10 Wow, well that's cool. - Draker (Eugene, OR) 17:02:05 05/12/10 so, nobody contesting? - KasbeKZ(VA) 16:51:35 05/12/10 It does go to the bell housing for sure. (n/m) - Draker (Eugene, OR) 17:02:33 05/12/10 ok. i just got out there and looked around - KasbeKZ(VA) 17:44:19 05/12/10 yeah nm. i'm sure that's it (n/m) - KasbeKZ(VA) 18:51:29 05/12/10 It's goes on the top tranny bolt, 1 o'clock position. - Woody75 (Denver) 08:42:02 05/13/10 past that loop, in the picture, the wire continues - KasbeKZ(VA) 11:02:27 05/13/10 Hmm, stock it doesn't connect to the exhaust manifold. (n/m) - Woody75 (Denver) 15:26:55 05/13/10 very strange. i'll investigate further. - KasbeKZ(VA) 06:52:11 05/14/10
Post a Followup	You cannot reply to this message because you are not logged in.