Subject	ok. i just got out there and looked around
Posted by	KasbeKZ(VA) on May 12, 2010 at 5:44 PM
	This message has been viewed 65 times.
In Reply To	It does go to the bell housing for sure. (n/m) posted by Draker (Eugene, OR) on May 12, 2010 at 05:02 PM
Message	bell housing looks good because there's no ground there now. just to clarify, this is the wire directly from the negative terminal, connected to the fire wall and to an exhaust manifold stud on the other ends. still sound right? i'm just asking for clarification because it is stretching it pretty tight to get it over there to the bell housing.
Follow Ups	another ground question - KasbeKZ(VA) 19:07:15 05/11/10 That go's to trans bellhousing bolt (n/m) - njz 19:36:52 05/11/10 oh... so that hasn't been hooked up for a while... - KasbeKZ(VA) 19:58:16 05/11/10 Did it still start with it disconnected? (n/m) - Draker (Eugene, OR) 20:25:37 05/11/10 if it actually hooks to a bell housing bolt, then yeah - KasbeKZ(VA) 05:46:48 05/12/10 Wow, well that's cool. - Draker (Eugene, OR) 17:02:05 05/12/10 so, nobody contesting? - KasbeKZ(VA) 16:51:35 05/12/10 It does go to the bell housing for sure. (n/m) - Draker (Eugene, OR) 17:02:33 05/12/10 ok. i just got out there and looked around - KasbeKZ(VA) 17:44:19 05/12/10 yeah nm. i'm sure that's it (n/m) - KasbeKZ(VA) 18:51:29 05/12/10 It's goes on the top tranny bolt, 1 o'clock position. - Woody75 (Denver) 08:42:02 05/13/10 past that loop, in the picture, the wire continues - KasbeKZ(VA) 11:02:27 05/13/10 Hmm, stock it doesn't connect to the exhaust manifold. (n/m) - Woody75 (Denver) 15:26:55 05/13/10 very strange. i'll investigate further. - KasbeKZ(VA) 06:52:11 05/14/10
Post a Followup	You cannot reply to this message because you are not logged in.