Subject	You guys are working to hard
Posted by	Spddracer on May 12, 2010 at 11:41 AM
	This message has been viewed 133 times.
In Reply To	There was an article,I believe from Gordo 93TT NYC posted by RICH1 on May 11, 2010 at 06:41 AM
Message	You MUST make sure of adjustment at the pedal is loose enough before the system will bleed correctly. If you cannot get the air out, Loosen up the adjustment at the pedal clevis a little, then re bleed the system, It is not hard to bleed unless the pedal adjustment is to tight. You can bleed the system until you run the country out of brake fluid and it will never work with the pedal adjustment to tight. Thread the master rod into the pedal clevis a turn or 2 and try to re bleed the system, Then adjust the pedal again after the air is out. www.Zspeedperformance.com
Follow Ups	Clutch adjustment problem - RICH1 13:51:07 05/10/10 I having clutch BS too w/ my Max Street - SuparexTT 22:44:09 05/10/10 There was an article,I believe from Gordo 93TT NYC - RICH1 06:41:04 05/11/10 My "new" slave is from Rock Auto, so it's not OEM. - SuparexTT 07:26:27 05/11/10 You guys are working to hard - Spddracer 11:41:41 05/12/10 Joe, we will make sure we do that as well. (n/m) - RICH1 15:13:24 05/12/10 One part of that info is bad...... - Greg D. (Specialty-Z) 08:16:10 05/13/10 It doesnt say anywhere in what I said to tighten the pedal - Spddracer 14:39:30 05/13/10 Understood, It just leaves that impression...... - Greg D. (Specialty-Z) 14:56:45 05/13/10 Are you guys vacuum bleeding, or doing it manually? (n/m) - canyoncarver 20:05:47 05/11/10 Doing it manually. (n/m) - RICH1 14:08:17 05/12/10 I had the same problem. - yobobrox 16:26:26 05/12/10 Only 1 correct way to get the max adjustment and still allow - Greg D. (Specialty-Z) 20:30:54 05/12/10 BTW Air in the line has nothing to do ................. - Greg D. (Specialty-Z) 20:37:28 05/12/10 Here is a test you can do........ - Greg D. (Specialty-Z) 13:02:12 05/13/10 And this is the next test........ - Greg D. (Specialty-Z) 13:21:50 05/13/10 Or the fork is on wrong, TOB is not all the way on the sleev - Spddracer 16:29:14 05/13/10
Post a Followup	You cannot reply to this message because you are not logged in.