Subject	There was an article,I believe from Gordo 93TT NYC
Posted by	RICH1 on May 11, 2010 at 6:41 AM
	This message has been viewed 145 times.
In Reply To	I having clutch BS too w/ my Max Street posted by SuparexTT on May 10, 2010 at 10:44 PM
Message	That perfectly described the problem. I think I have a slave cylinder that leaked in some air while we were changing the clutch and we just didn't bleed it enough. I think I might try installing the new slave cylinder and re-bleed the system. If that doesn't get us anywhere then I can install the new Master Cylinder as well. Rich1 90TT
Follow Ups	Clutch adjustment problem - RICH1 13:51:07 05/10/10 I having clutch BS too w/ my Max Street - SuparexTT 22:44:09 05/10/10 There was an article,I believe from Gordo 93TT NYC - RICH1 06:41:04 05/11/10 My "new" slave is from Rock Auto, so it's not OEM. - SuparexTT 07:26:27 05/11/10 You guys are working to hard - Spddracer 11:41:41 05/12/10 Joe, we will make sure we do that as well. (n/m) - RICH1 15:13:24 05/12/10 One part of that info is bad...... - Greg D. (Specialty-Z) 08:16:10 05/13/10 It doesnt say anywhere in what I said to tighten the pedal - Spddracer 14:39:30 05/13/10 Understood, It just leaves that impression...... - Greg D. (Specialty-Z) 14:56:45 05/13/10 Are you guys vacuum bleeding, or doing it manually? (n/m) - canyoncarver 20:05:47 05/11/10 Doing it manually. (n/m) - RICH1 14:08:17 05/12/10 I had the same problem. - yobobrox 16:26:26 05/12/10 Only 1 correct way to get the max adjustment and still allow - Greg D. (Specialty-Z) 20:30:54 05/12/10 BTW Air in the line has nothing to do ................. - Greg D. (Specialty-Z) 20:37:28 05/12/10 Here is a test you can do........ - Greg D. (Specialty-Z) 13:02:12 05/13/10 And this is the next test........ - Greg D. (Specialty-Z) 13:21:50 05/13/10 Or the fork is on wrong, TOB is not all the way on the sleev - Spddracer 16:29:14 05/13/10
Post a Followup	You cannot reply to this message because you are not logged in.