Subject	Welcome. It does help to hold everything in place, but not..
Posted by	Ziceman(East TN) on May 05, 2010 at 1:56 PM
	This message has been viewed 111 times.
In Reply To	Thanks for the pic. I've got the orientation correct. posted by ZTicket(Dallas) on May 05, 2010 at 01:46 PM
Message	... necessary for sure. A little advise if I may, make sure that your line up tool pulls out easy before you stab the transmission. I had read were a guy stated to imagine you are pulling the line up tool out with a wet piece of tissue. If the line up tool pulls out that easy then it should go back in with out issue.
Follow Ups	Just finished installing my SpecialtyZ Flywheel & - ZTicket(Dallas) 21:46:02 05/04/10 Top shield is behind the flywheel.. - Draker (Eugene, OR) 00:12:56 05/05/10 Let me be a little more clear. My concern is with the lower - ZTicket(Dallas) 06:50:54 05/05/10 It goes between the large shield and the engine/block. - Woody75 (Denver) 10:43:11 05/05/10 Thanks man. Now, since I didn't attach them to each - ZTicket(Dallas) 12:02:40 05/05/10 Here is what it should look like. The small bolt that ...... - Ziceman(East TN) 13:22:50 05/05/10 Thanks for the pic. I've got the orientation correct. - ZTicket(Dallas) 13:46:32 05/05/10 Welcome. It does help to hold everything in place, but not.. - Ziceman(East TN) 13:56:52 05/05/10 I've never found a set bolted together yet. - Woody75 (Denver) 14:17:09 05/05/10 Decided to take clutch/flywheel off and bolt up the - ZTicket(Dallas) 09:53:30 05/06/10
Post a Followup	You cannot reply to this message because you are not logged in.