Subject	Thanks for the pic. I've got the orientation correct.
Posted by	ZTicket(Dallas) on May 05, 2010 at 1:46 PM
	This message has been viewed 114 times.
In Reply To	Here is what it should look like. The small bolt that ...... posted by Ziceman(East TN) on May 05, 2010 at 01:22 PM
Message	and I'll just do what the guy did before me and leave the bolt out. I imagine it will be a little frustrating trying to stab the tranny and put the lower shield in place long enough to get a bolt started. I'll manage. Thanks again for the pic.
Follow Ups	Just finished installing my SpecialtyZ Flywheel & - ZTicket(Dallas) 21:46:02 05/04/10 Top shield is behind the flywheel.. - Draker (Eugene, OR) 00:12:56 05/05/10 Let me be a little more clear. My concern is with the lower - ZTicket(Dallas) 06:50:54 05/05/10 It goes between the large shield and the engine/block. - Woody75 (Denver) 10:43:11 05/05/10 Thanks man. Now, since I didn't attach them to each - ZTicket(Dallas) 12:02:40 05/05/10 Here is what it should look like. The small bolt that ...... - Ziceman(East TN) 13:22:50 05/05/10 Thanks for the pic. I've got the orientation correct. - ZTicket(Dallas) 13:46:32 05/05/10 Welcome. It does help to hold everything in place, but not.. - Ziceman(East TN) 13:56:52 05/05/10 I've never found a set bolted together yet. - Woody75 (Denver) 14:17:09 05/05/10 Decided to take clutch/flywheel off and bolt up the - ZTicket(Dallas) 09:53:30 05/06/10
Post a Followup	You cannot reply to this message because you are not logged in.