Subject	Re: z32 tranny won't go into gear. (mazworx kit)
Posted by	95Gstman on April 29, 2010 at 12:32 AM
	This message has been viewed 89 times.
In Reply To	z32 tranny won't go into gear. (mazworx kit) posted by 95Gstman on April 28, 2010 at 06:29 PM
Message	:Okay guys, I am in the process of installing a vh45 and z32 tranny in my 240. I have the engine in the bay and the transmission bolted up but for some reason the striking arm/shifter seem to be sitting at an angle away from the driver. I can not get the transmission to go into more that two gears. I was wondering if I could have possibly installed the striking arm upside down? It can only be installed two ways due to the fact that you have to put a pin in it. Anyone have any ideas? Thanks for the help. :This is the part of the transmission I am talking about in case clarification is needed. :[ http://www.z1motorsports.com/product_in ] ... ts_id=1936 Here are some pictures of what I am talking about. [ http://s165.photobucket.com/albums/u76/ ] ... C02123.jpg [ http://s165.photobucket.com/albums/u76/ ] ... C02124.jpg [ http://s165.photobucket.com/albums/u76/ ] ... C02125.jpg [ http://s165.photobucket.com/albums/u76/ ] ... C02126.jpg
Follow Ups	z32 tranny won't go into gear. (mazworx kit) - 95Gstman 18:29:25 04/28/10 Re: z32 tranny won't go into gear. (mazworx kit) - 95Gstman 00:32:29 04/29/10 I can't see the pictures but.. - TheSlimOne 08:30:12 04/29/10
Post a Followup	You cannot reply to this message because you are not logged in.