Subject	INfo....
Posted by	Greg D. (Specialty-Z) on April 26, 2010 at 8:20 PM
	This message has been viewed 133 times.
In Reply To	My clutch sounds like a Duck being Murdered. Help? posted by Nikknakz on April 25, 2010 at 11:45 PM
Message	What your describing can only be caused from the Disc material engaging the flywheel. What can cause this is the type of material in the Disc or from a overheated pressure plate that has hard spots. The then steel flywheel's have this happen more commonly than thick steel or aluminum flywheels.
Follow Ups	My clutch sounds like a Duck being Murdered. Help? - Nikknakz 23:45:50 04/25/10 Depends on how you look at it. - Draker (Eugene, OR) 02:06:54 04/26/10 i've had a similar problem - KasbeKZ(VA) 07:17:36 04/26/10 Your Noise would be Classic T.O. bearing (n/m) - Greg D. (Specialty-Z) 20:21:36 04/26/10 You could try lubing up the release lever pivot ball before - Audioquest 08:16:31 04/26/10 INfo.... - Greg D. (Specialty-Z) 20:20:35 04/26/10 Sounds like a bad/worn pilot bushing to me. - Spddracer 20:59:44 04/26/10
Post a Followup	You cannot reply to this message because you are not logged in.