Subject	One more thing......
Posted by	Greg D. (Specialty-Z) on April 26, 2010 at 7:52 PM
	This message has been viewed 123 times.
In Reply To	Answers..... posted by Greg D. (Specialty-Z) on April 26, 2010 at 07:45 PM
Message	More than likely the reason you lost pressure was because the slave probably overextended..... When freeplay does not exist the fluid can not push back into the master and pressure builds......the hotter it gets the more the clutch will be forced to release. If you get it hot enough it will push the slave out past the seal and the fluid will dump ;-)
Follow Ups	Local Z owner clutch woes, need serious advice. - ZiNnYc 09:25:23 04/26/10 Flywheel resurfaced each time? (n/m) - Eric(FL) 09:48:58 04/26/10 no...but pressure loss this time around? good point tho. (n/m) - ZiNnYc 18:37:14 04/26/10 Sounds as if the slave cylinder may still be exerting - SlicktopTT 11:47:44 04/26/10 He did have an older RPS clutch. I will ask about the SC. - ZiNnYc 18:38:01 04/26/10 Answers..... - Greg D. (Specialty-Z) 19:45:45 04/26/10 One more thing...... - Greg D. (Specialty-Z) 19:52:17 04/26/10
Post a Followup	You cannot reply to this message because you are not logged in.