Subject	Depends on how you look at it.
Posted by	Draker (Eugene, OR) on April 26, 2010 at 2:06 AM
	This message has been viewed 90 times.
In Reply To	My clutch sounds like a Duck being Murdered. Help? posted by Nikknakz on April 25, 2010 at 11:45 PM
Message	Dropping the tranny can be pretty easy. If you are going to drop it then its clutch time. When was the last time it was replaced? When you do the clutch you are going to resurface the flywheel, new throw out bearing, new pilot bushing, grease the pivot ball, replace the rear main seal. I'm confident when you pull it down, and if you know what you are looking at, it will be obvious what the problem is.
Follow Ups	My clutch sounds like a Duck being Murdered. Help? - Nikknakz 23:45:50 04/25/10 Depends on how you look at it. - Draker (Eugene, OR) 02:06:54 04/26/10 i've had a similar problem - KasbeKZ(VA) 07:17:36 04/26/10 Your Noise would be Classic T.O. bearing (n/m) - Greg D. (Specialty-Z) 20:21:36 04/26/10 You could try lubing up the release lever pivot ball before - Audioquest 08:16:31 04/26/10 INfo.... - Greg D. (Specialty-Z) 20:20:35 04/26/10 Sounds like a bad/worn pilot bushing to me. - Spddracer 20:59:44 04/26/10
Post a Followup	You cannot reply to this message because you are not logged in.