Subject	Also, you can erase the "RE ..." line, so we don't have
Posted by	zellamay on April 13, 2010 at 2:29 PM
	This message has been viewed 101 times.
In Reply To	Re: Is the timing belt sitting correctly on the cam gears? posted by twin3037 on April 13, 2010 at 12:15 PM
Message	to read the same line twice.
Follow Ups	120k service idler pulley question - twin3037 11:10:51 04/12/10 Not sure what you are describing. Why would the >>> - ZUL8TR 13:15:43 04/12/10 You installed the stud backwards. (n/m) - ZiNnYc 14:27:10 04/12/10 Re: 120k service idler pulley question - twin3037 14:37:08 04/12/10 The pulleys don't sit flush, they need to sit an inch or so - ZiNnYc 14:53:56 04/12/10 Re: The pulleys don't sit flush, they need to sit an inch or so - twin3037 15:02:21 04/12/10 Take an actual picture. (n/m) - ZiNnYc 15:12:40 04/12/10 Pulleys do sit flush. They don't float off the block. - Zarcasm(Hfd, CT) 11:35:37 04/13/10 Re: 120k service idler pulley question - twin3037 16:45:41 04/12/10 I might have an extra idler pulley around but id have to - 5280Z_nightstalker 01:55:47 04/13/10 Pully definately sticks out too far since it looks >>> - ZUL8TR 06:53:00 04/13/10 Is the timing belt sitting correctly on the cam gears? - Woody75 (Denver) 08:14:46 04/13/10 Re: Is the timing belt sitting correctly on the cam gears? - twin3037 12:15:17 04/13/10 Also, you can erase the "RE ..." line, so we don't have - zellamay 14:29:49 04/13/10 Did you compare new parts to old parts? - zellamay 21:48:56 04/12/10 Re: Did you compare new parts to old parts? - twin3037 22:54:59 04/12/10 So take them off and do it now, unless someone - zellamay 01:55:12 04/13/10
Post a Followup	You cannot reply to this message because you are not logged in.