Subject	Re: Did you set the base idle after replacing the IACV?
Posted by	Andy_M on April 01, 2010 at 8:19 AM
	This message has been viewed 202 times.
In Reply To	Did you set the base idle after replacing the IACV? (n/m) posted by Eric(FL) on March 31, 2010 at 01:43 PM
Message	I did, but maybe I didn't follow the right procedure. I will recheck the Tech doc. Andy_M atmorris@ptd.net (home)
Follow Ups	Changed IACV and fixed vacuum leak - now idle issue - Andy_M 12:51:02 03/31/10 Did you set the base idle after replacing the IACV? (n/m) - Eric(FL) 13:43:43 03/31/10 Re: Did you set the base idle after replacing the IACV? - Andy_M 08:19:15 04/01/10 I did, but maybe I didn't follow the right procedure.... (n/m) - Andy_M 08:21:48 04/01/10 Yea, that is how I set the base idle but the tech doc says: - Andy_M 08:31:30 04/01/10 Ok,just read another post that says to set base idle... - Andy_M 08:57:22 04/01/10 Correction - Andy_M 08:16:35 04/01/10 Re: Base idle set correctly...now VERY low cold idle - Andy_M 09:50:08 04/05/10
Post a Followup	You cannot reply to this message because you are not logged in.