Subject	Yep! Still having problems with it.
Posted by	Kels300Z on March 16, 2010 at 10:52 PM
	This message has been viewed 75 times.
In Reply To	Do you have the ball joint press that he uses later in the posted by Wright (Ca) on March 16, 2010 at 10:35 PM
Message	I have the exact one he used. Did you have to do anything fancy to rig the press? I've tried a couple of different ways but no joy -- the sticking point in the process is the hole in the end of the press that the c-clamp doesn't have; that or the whole thing slipping off and falling to the ground. The day you stop learning about this car is the day you're no longer an enthusiast.
Follow Ups	Ball joint assembly removal is at a standstill. Suggestions? - Kels300Z 22:12:00 03/16/10 Do you have the ball joint press that he uses later in the - Wright (Ca) 22:35:32 03/16/10 Yep! Still having problems with it. - Kels300Z 22:52:47 03/16/10 I couldn't have done it without a second set of hands. Also, - Wright (Ca) 23:08:43 03/16/10 Thanks Wright! Any advice is very helpful at this point - Kels300Z 23:27:18 03/16/10 Re: Ball joint assembly removal is at a standstill. Suggestions? - lurker_nz 23:33:42 03/16/10 Nice! I will definitely try that as well. Thanks lurker! (n/m) - Kels300Z 23:36:44 03/16/10 Success! SPL solids are now in place! Many thanks again. (n/m) - Kels300Z 14:54:08 03/17/10
Post a Followup	You cannot reply to this message because you are not logged in.