Subject	Thank you everyone for the help.
Posted by	cHiNgLeZ on March 15, 2010 at 3:24 PM
	This message has been viewed 67 times.
In Reply To	Re: Help Please: Starter Installation posted by draker on March 15, 2010 at 01:02 PM
Message	I just spent another hour trying to figure this out and confirm that the stud was sheared off. I have an automatic NA, and for the curious, my stud was located on the top. Hopefully, I can get this broken stud out, and the car up and running shortly. By the way, lying on your back and trying to wiggle the starter around for what felt like an hour is not easy! My arms are burning, and it just feels like I had the most intense workout of my life! Thanks again guys.
Follow Ups	Help Please: Starter Installation - cHiNgLeZ 22:55:05 03/14/10 Re: Help Please: Starter Installation - draker 23:55:40 03/14/10 Arghhh how wonderful... - cHiNgLeZ 00:35:19 03/15/10 Re: Arghhh how wonderful... - draker 01:00:44 03/15/10 Oh hold on a sec...I thought this stud was on the top. - cHiNgLeZ 01:17:19 03/15/10 Hmm so I read through a few posts while searching and found - cHiNgLeZ 02:38:26 03/15/10 Turn the motor over by hand a few times after replacing... - musky 08:59:01 03/15/10 just use a "bolt extractor"- should be pretty easy - musky 01:08:47 03/15/10 Also consider some heat on the aluminum (20 secs or so)>> - ZUL8TR 06:49:42 03/15/10 the easiest way to get that out of a tight spot like that - KasbeKZ(VA) 09:59:30 03/15/10 Re: Help Please: Starter Installation - draker 13:02:50 03/15/10 Thank you everyone for the help. - cHiNgLeZ 15:24:56 03/15/10 Drill and tap make sure you have a good drill - John (MD) 08:15:01 03/16/10
Post a Followup	You cannot reply to this message because you are not logged in.