Subject	the easiest way to get that out of a tight spot like that
Posted by	KasbeKZ(VA) on March 15, 2010 at 9:59 AM
	This message has been viewed 71 times.
In Reply To	Help Please: Starter Installation posted by cHiNgLeZ on March 14, 2010 at 10:55 PM
Message	is to source a drill with a 90 degree head and use a reverse drill bit, undersized of course. once you get deep enough in it it will likely start to back out, and if not, then you can just figure out something new. it won't be hard at that point. there are tools that are perfect for that situation.
Follow Ups	Help Please: Starter Installation - cHiNgLeZ 22:55:05 03/14/10 Re: Help Please: Starter Installation - draker 23:55:40 03/14/10 Arghhh how wonderful... - cHiNgLeZ 00:35:19 03/15/10 Re: Arghhh how wonderful... - draker 01:00:44 03/15/10 Oh hold on a sec...I thought this stud was on the top. - cHiNgLeZ 01:17:19 03/15/10 Hmm so I read through a few posts while searching and found - cHiNgLeZ 02:38:26 03/15/10 Turn the motor over by hand a few times after replacing... - musky 08:59:01 03/15/10 just use a "bolt extractor"- should be pretty easy - musky 01:08:47 03/15/10 Also consider some heat on the aluminum (20 secs or so)>> - ZUL8TR 06:49:42 03/15/10 the easiest way to get that out of a tight spot like that - KasbeKZ(VA) 09:59:30 03/15/10 Re: Help Please: Starter Installation - draker 13:02:50 03/15/10 Thank you everyone for the help. - cHiNgLeZ 15:24:56 03/15/10 Drill and tap make sure you have a good drill - John (MD) 08:15:01 03/16/10
Post a Followup	You cannot reply to this message because you are not logged in.