Subject	Hmm so I read through a few posts while searching and found
Posted by	cHiNgLeZ on March 15, 2010 at 2:38 AM
	This message has been viewed 68 times.
In Reply To	Re: Arghhh how wonderful... posted by draker on March 15, 2010 at 01:00 AM
Message	out that the stud might actually go on the bottom, and the bolt on the top. I was a little confused, because apparently for auto and manual transmissions, the the stud and bolt are located in opposite directions. I'll try again tomorrow and report back. Thank you for the help all!
Follow Ups	Help Please: Starter Installation - cHiNgLeZ 22:55:05 03/14/10 Re: Help Please: Starter Installation - draker 23:55:40 03/14/10 Arghhh how wonderful... - cHiNgLeZ 00:35:19 03/15/10 Re: Arghhh how wonderful... - draker 01:00:44 03/15/10 Oh hold on a sec...I thought this stud was on the top. - cHiNgLeZ 01:17:19 03/15/10 Hmm so I read through a few posts while searching and found - cHiNgLeZ 02:38:26 03/15/10 Turn the motor over by hand a few times after replacing... - musky 08:59:01 03/15/10 just use a "bolt extractor"- should be pretty easy - musky 01:08:47 03/15/10 Also consider some heat on the aluminum (20 secs or so)>> - ZUL8TR 06:49:42 03/15/10 the easiest way to get that out of a tight spot like that - KasbeKZ(VA) 09:59:30 03/15/10 Re: Help Please: Starter Installation - draker 13:02:50 03/15/10 Thank you everyone for the help. - cHiNgLeZ 15:24:56 03/15/10 Drill and tap make sure you have a good drill - John (MD) 08:15:01 03/16/10
Post a Followup	You cannot reply to this message because you are not logged in.