Subject	Arghhh how wonderful...
Posted by	cHiNgLeZ on March 15, 2010 at 12:35 AM
	This message has been viewed 72 times.
In Reply To	Re: Help Please: Starter Installation posted by draker on March 14, 2010 at 11:55 PM
Message	You're sure about this? And there is no other way of solving this problem? Sorry, I'm just a little frustrated because I spent so long prepping the car for spring, and this had to happen. Thanks for your help though.
Follow Ups	Help Please: Starter Installation - cHiNgLeZ 22:55:05 03/14/10 Re: Help Please: Starter Installation - draker 23:55:40 03/14/10 Arghhh how wonderful... - cHiNgLeZ 00:35:19 03/15/10 Re: Arghhh how wonderful... - draker 01:00:44 03/15/10 Oh hold on a sec...I thought this stud was on the top. - cHiNgLeZ 01:17:19 03/15/10 Hmm so I read through a few posts while searching and found - cHiNgLeZ 02:38:26 03/15/10 Turn the motor over by hand a few times after replacing... - musky 08:59:01 03/15/10 just use a "bolt extractor"- should be pretty easy - musky 01:08:47 03/15/10 Also consider some heat on the aluminum (20 secs or so)>> - ZUL8TR 06:49:42 03/15/10 the easiest way to get that out of a tight spot like that - KasbeKZ(VA) 09:59:30 03/15/10 Re: Help Please: Starter Installation - draker 13:02:50 03/15/10 Thank you everyone for the help. - cHiNgLeZ 15:24:56 03/15/10 Drill and tap make sure you have a good drill - John (MD) 08:15:01 03/16/10
Post a Followup	You cannot reply to this message because you are not logged in.