Subject	When I went to one-piece on my first Z32, an NA, it
Posted by	zellamay on February 25, 2010 at 9:40 PM
	This message has been viewed 154 times.
In Reply To	Re: Read up on it first, it depends on your goals. There ma posted by March.Prince on February 25, 2010 at 08:51 PM
Message	acquired this very small buzzy vibration, almost imperceptible at some speeds, very noticable at other speeds. (I did all the clocking positions). It was annoying to me, but to those with rougher cars due to aftermarket stuff, the vibration might not be bothersome. Again, don't take my word, or the few that you will get on this thread, "search" and read up on it. ... Also, you can remove the lead line that says "Re: ... " so people don't have to read the same words twice.
Follow Ups	Drive shaft going out? - March.Prince 20:30:01 02/25/10 Center support bearings go bad. Replace it. - ZLover4Life 20:31:09 02/25/10 link inside - ZLover4Life 20:34:24 02/25/10 Thanks for the link BTW (n/m) - March.Prince 11:21:58 02/26/10 or... - KasbeKZ(VA) 20:35:48 02/25/10 Re: or... - March.Prince 20:38:07 02/25/10 as zlover said, do confirm the ds first through - KasbeKZ(VA) 20:43:20 02/25/10 Re: as zlover said, do confirm the ds first through - March.Prince 20:47:45 02/25/10 search "vibration" while you're at it... - ZLover4Life 20:51:13 02/25/10 Read up on it first, it depends on your goals. There may - zellamay 20:45:44 02/25/10 Re: Read up on it first, it depends on your goals. There ma - March.Prince 20:51:33 02/25/10 When I went to one-piece on my first Z32, an NA, it - zellamay 21:40:28 02/25/10 Point taken (n/m) - March.Prince 23:16:16 02/25/10 There is definitely more NVH with a 1-piece. - ZiNnYc 22:57:37 02/25/10 well this def gives me a better understanding - March.Prince 23:14:55 02/25/10 I don't think you understood my post. - ZiNnYc 23:28:04 02/25/10 got it. - March.Prince 10:14:23 02/26/10 You imply that the CSB has so much resistance... - ZLover4Life 12:29:48 02/26/10 RE: - March.Prince 17:02:52 02/26/10 the biggest benefit is reliability. for me anyway - KasbeKZ(VA) 19:57:12 02/26/10 Re: - March.Prince 20:22:07 02/26/10 all what stuff? u-joints=unserviceable. so i've been told (n/m) - KasbeKZ(VA) 21:59:23 02/26/10 there's very little (if any) performance gain - ZLover4Life 01:44:42 02/26/10 Makes sense - March.Prince 10:18:12 02/26/10 My Powertrain 1-pc AL shaft was something ridiculous - BigTDogg (MA) 11:53:33 02/28/10 i've ridden in two z's with 1-pieces, - KasbeKZ(VA) 21:04:52 02/25/10 I have a 92 na and tried the 1 piece and was not satisfied > - ZUL8TR 09:45:19 02/26/10 found this nifty site with you guys explaining this - March.Prince 20:57:34 02/26/10
Post a Followup	You cannot reply to this message because you are not logged in.