Subject	Intake piping; corner ends, can it be modified?
Posted by	VigorousZX on February 25, 2010 at 6:37 PM
	This message has been viewed 191 times.
Message	Greeting gentlemen, I am widening my Z headlights for an exterior kit Im building. Problem is, where the intake piping ends is where I must place the light housing. It appears that air flow comes to this end and is just rerouted into the car. So is it okay to remove the top seal and place the headlights over it or must this be sealed in its stock form? thanks : The Zionists' interest bearing and mathematically recursive econo-political system of promoting financial slavery has been exposed! -anonymous
Follow Ups	Intake piping; corner ends, can it be modified? - VigorousZX 18:37:21 02/25/10 Get a pop charger and you can just remove those (n/m) - na300zx (OH) 18:49:10 02/25/10 Big 2nd. That should have been your 1st upgrade! (n/m) - JonnyZ(SoCal) 00:14:48 02/26/10 Re: Get a pop charger and you can just remove those - VigorousZX 14:56:24 02/26/10
Post a Followup	You cannot reply to this message because you are not logged in.