Subject	Definately AFM.......
Posted by	zx299 on February 25, 2010 at 5:43 AM
	This message has been viewed 98 times.
In Reply To	I agree with above, MAF...(more) posted by Snowmansdsm09 on February 25, 2010 at 12:17 AM
Message	When the ECU detects a malfunction in the AFM it uses the "limp mode" table which allows you to still drive the car with a rev limit of 2400rpm. It uses the TPS input as an AFM substitute. "If you own a 300zx, you don't have time for a hobby" "If you own more than one 300zx, you don't have time for a life"
Follow Ups	My car won't go past 2500 RPM - texasman80 14:29:52 02/24/10 It will run without the maf hooked up. - Josher 14:36:36 02/24/10 Re: It will run without the maf hooked up. - texasman80 14:49:53 02/24/10 They will run w/out MAF, but barely.... - ZXoltan 15:11:45 02/24/10 Could use consult to check proper voltage output of MAF (n/m) - RevTech 15:13:57 02/24/10 Re: Could use consult to check proper voltage output of MAF - texasman80 13:46:16 02/26/10 Wrong forum dogg (n/m) - BigTDogg (MA) 15:23:56 02/24/10 Re: Wrong forum dogg - texasman80 15:45:18 02/24/10 Check your base timing, after it starts and warms up (n/m) - BigTDogg (MA) 16:28:26 02/24/10 I agree with above, MAF...(more) - Snowmansdsm09 00:17:32 02/25/10 Definately AFM....... - zx299 05:43:38 02/25/10 Re: Definately AFM....... - Snowmansdsm09 23:24:16 02/25/10
Post a Followup	You cannot reply to this message because you are not logged in.