Subject	I agree with above, MAF...(more)
Posted by	Snowmansdsm09 on February 25, 2010 at 12:17 AM
	This message has been viewed 151 times.
In Reply To	My car won't go past 2500 RPM posted by texasman80 on February 24, 2010 at 02:29 PM
Message	I had the same problem, and is the reason I bought my car so cheap. The guy couldn't figure it out. So I set out to see if it was a major boost leak or the MAF sensor. I fixed all boost leaks and then bought a new MAF, the MAF sensor fixed the issue. If you have already tried known good MAF sensors, then i would next make sure the terminals on the connector going to the MAF is free of corrosion. Then check ground resistance, and resistance from MAF connector to ECU connector. But this issue is a classic MAF symptom!
Follow Ups	My car won't go past 2500 RPM - texasman80 14:29:52 02/24/10 It will run without the maf hooked up. - Josher 14:36:36 02/24/10 Re: It will run without the maf hooked up. - texasman80 14:49:53 02/24/10 They will run w/out MAF, but barely.... - ZXoltan 15:11:45 02/24/10 Could use consult to check proper voltage output of MAF (n/m) - RevTech 15:13:57 02/24/10 Re: Could use consult to check proper voltage output of MAF - texasman80 13:46:16 02/26/10 Wrong forum dogg (n/m) - BigTDogg (MA) 15:23:56 02/24/10 Re: Wrong forum dogg - texasman80 15:45:18 02/24/10 Check your base timing, after it starts and warms up (n/m) - BigTDogg (MA) 16:28:26 02/24/10 I agree with above, MAF...(more) - Snowmansdsm09 00:17:32 02/25/10 Definately AFM....... - zx299 05:43:38 02/25/10 Re: Definately AFM....... - Snowmansdsm09 23:24:16 02/25/10
Post a Followup	You cannot reply to this message because you are not logged in.