Subject	using Jaidieray's site this is what your looking at
Posted by	5280Z_nightstalker on February 21, 2010 at 11:51 PM
	This message has been viewed 108 times.
In Reply To	wheel offset simplicity please posted by drg187 on February 21, 2010 at 05:47 PM
Message	Front: The clearance from stut housing to the inside of the wheel will be 12mm MORE The outside edge of the wheel will EXTEND an extra 38mm (1.5") Rear: The clearance from stut housing to the inside of the wheel will be 9mm LESS The outside edge of the wheel will EXTEND an extra 29mm (1.15") I run F=8.5+25mm, R=10+30mm our setups are similar but your wheels will be pushed out an extra .2". In my opinion my setup is the absolute farthest you can go on the rears I am at the very edge the fronts would probably fit but be very close you might need a fender roll. Hope all this makes sense and helps "Do you guys put the key in "balls down", or up?" -BobbyT 10:28:19 03/06/09
Follow Ups	wheel offset simplicity please - drg187 17:47:09 02/21/10 Re: wheel offset simplicity please - jaidieray 18:17:23 02/21/10 using Jaidieray's site this is what your looking at - 5280Z_nightstalker 23:51:59 02/21/10 Re: using Jaidieray's site this is what your looking at - drg187 01:38:49 02/22/10 Yes my Z is factory ride height I am working on getting - 5280Z_nightstalker 14:33:40 02/22/10 Re: Yes my Z is factory ride height I am working on getting - drg187 17:18:32 02/22/10 soon youll be hellaflush - drg187 17:23:55 02/22/10 Not quiet sure why you want hubcentric rings but I think - 5280Z_nightstalker 17:36:57 02/22/10 Hub centric rings are a must for aftermarket wheels - Bernie (NoVA) 09:05:32 02/24/10 I know but it just seemed like a topic out of left field - 5280Z_nightstalker 14:31:11 02/24/10 Re: wheel offset simplicity please - Dane (Houston) 02:55:47 02/22/10
Post a Followup	You cannot reply to this message because you are not logged in.