Subject	1 mm measured at 3 & 9 O'clock on a 16-18" rim would
Posted by	Gordo 93TT Daytona on February 21, 2010 at 10:24 PM
	This message has been viewed 154 times.
In Reply To	alignment question posted by KasbeKZ(VA) on February 19, 2010 at 12:32 AM
Message	not be that different measured at 8&4. It would be a little less than 1mm, but considering the length of the measured tangents, the differences would not be much. Use your geometry training. The differences as measured from the center of your wheel hub are about an inch or two on the rim, and the overall toe is across the diameter of the full tire... like 25-28". IMO, the inherent error in the backyard mechanic measuring instruments is going to be greater than the differences you are concerned about. _________________________________________________
Follow Ups	alignment question - KasbeKZ(VA) 00:32:04 02/19/10 Get it on a real alignment rack - Drk93TT 13:18:01 02/19/10 i'm aware of that option. - KasbeKZ(VA) 13:28:13 02/19/10 I have done manual DIY alignment many times for >>> - ZUL8TR 09:25:28 02/20/10 thanks - KasbeKZ(VA) 01:09:26 02/21/10 Show us a pic of the tool. If you can't get an equation>> - ZUL8TR 06:35:41 02/21/10 1 mm measured at 3 & 9 O'clock on a 16-18" rim would - Gordo 93TT Daytona 22:24:45 02/21/10
Post a Followup	You cannot reply to this message because you are not logged in.