Subject	so i reheated the metal (gently), refroze the plastic to
Posted by	sawbonez on February 21, 2010 at 7:04 AM
	This message has been viewed 111 times.
In Reply To	any tips to get new brake master cylinder resevoir posted by sawbonez on February 20, 2010 at 03:37 PM
Message	make the grommets less pliable and used large channel lock pliers to grab the master cylinder from below and a thick plastic tab immediately next to the plastic resivoir cup and finally got it seated.
Follow Ups	any tips to get new brake master cylinder resevoir - sawbonez 15:37:44 02/20/10 don't heat your master cylinder. there's rubber in it. (n/m) - KasbeKZ(VA) 16:45:32 02/20/10 How about heating the plastic instead? Freezing makes it - jzack 18:11:50 02/20/10 so i reheated the metal (gently), refroze the plastic to - sawbonez 07:04:12 02/21/10
Post a Followup	You cannot reply to this message because you are not logged in.