TwinTurbo.NET: Nissan 300ZX forum - You might have a problem at the pivot ball of the fork>>
People Seeking Info
 
   


     
Subject You might have a problem at the pivot ball of the fork>>
     
Posted by ZUL8TR on February 21, 2010 at 6:52 AM
  This message has been viewed 145 times.
     
In Reply To Re: There's air still in the system -- if the pedal gets hard posted by mkspriggs on February 20, 2010 at 07:01 PM
     
Message Could be the pivot ball is worn and the fork is somewhat displaced at the pivot. Pull the slave off and pull away the fork rubber boot and look in the bell housing to see if there is an issue at the ball by moving the fork a bit. Also might have an issue with the clutch pressure plate springs. But first make sure all air is out of the hydraulic system

ZUL8TR in Orlando,FL

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.