Subject	any tips to get new brake master cylinder resevoir
Posted by	sawbonez on February 20, 2010 at 3:37 PM
	This message has been viewed 126 times.
Message	onto existing master cylinder. rubber grommets will not slip inside master when on the plastic resevoir. i tried freezing the grommets/plastic resevoir and heating the metal master cylinder. i know it is press fit but just can't get it to fit. all parts fit separately but not with grommets on plastic cup
Follow Ups	any tips to get new brake master cylinder resevoir - sawbonez 15:37:44 02/20/10 don't heat your master cylinder. there's rubber in it. (n/m) - KasbeKZ(VA) 16:45:32 02/20/10 How about heating the plastic instead? Freezing makes it - jzack 18:11:50 02/20/10 so i reheated the metal (gently), refroze the plastic to - sawbonez 07:04:12 02/21/10
Post a Followup	You cannot reply to this message because you are not logged in.