Subject	i was using my avc-r's pressure sensor as a source
Posted by	Dane (Houston) on February 19, 2010 at 10:43 PM
	This message has been viewed 231 times.
In Reply To	Zeitronix with AVC-R MAP? posted by hijack on February 19, 2010 at 07:16 AM
Message	for my zeitronix. it worked okay but it always read 2 psi higher on the zeitronix display versus the apexi's. engine off i would have 2psi, but it was rose pound for pound. So it still served good for datalogging spool and referencing. Formerly SpecNATT (Houston)
Follow Ups	Zeitronix with AVC-R MAP? - hijack 07:16:27 02/19/10 Your sensor's voltage/boost characteristics would have to - Wright (Ca) 09:58:41 02/19/10 i found the specs for the zeitronix sensor: - hijack 11:18:24 02/19/10 I suppose you could pressurize your sensor and check voltage - Wright (Ca) 11:31:00 02/19/10 Yes, i got the info from the zeitronix website. - hijack 13:18:45 02/19/10 Here's what I found on my zeitronix sensor... - Wright (Ca) 22:23:19 02/19/10 I can't find anything on the AVC-R sensor. - hijack 19:33:45 02/20/10 i was using my avc-r's pressure sensor as a source - Dane (Houston) 22:43:20 02/19/10 That would make sense if the avc-r sensor is a 3.5 bar - Wright (Ca) 22:53:08 02/19/10 well i posted a response yesterday but it didn't appear - hijack 19:20:22 02/21/10
Post a Followup	You cannot reply to this message because you are not logged in.