Subject	Here's what I found on my zeitronix sensor...
Posted by	Wright (Ca) on February 19, 2010 at 10:23 PM
	This message has been viewed 1228 times.
In Reply To	Yes, i got the info from the zeitronix website. posted by hijack on February 19, 2010 at 01:18 PM
Message	Found printed on the side of the sensor: P255-50A-E4A A little google searching turned up this pdf: sensor The code would indicate that the sensor: -Has a pressure range of 0-50psi -Reference = Absolute -Seal Material = Fluorosilicone -Pressure Connection = 1/8-27 NPT -And has a electrical connection type: Mating connector, w/12”, 18 AWG leads Most importantly it states that it has a linear amplified output and that at 0psi voltage will be 0.50 ±0.08 Vdc, Full Pressure(50psi in my case): 4.50 ±0.08 Vdc. The zeitronix unit should be able to interpret your map sensor if it has these same voltage/pressure characteristics. I believe the zeitronix unit can also be configured to be used with a 0-75 psi sensor. Take a look at your sensor and see if it has any numbers that we can look up. Formerly: ZEVAN (Ca), Evan3zx(ca) Xbox live GT: kidding Me 1991 CRP TT 1993 Pearl White NA
Follow Ups	Zeitronix with AVC-R MAP? - hijack 07:16:27 02/19/10 Your sensor's voltage/boost characteristics would have to - Wright (Ca) 09:58:41 02/19/10 i found the specs for the zeitronix sensor: - hijack 11:18:24 02/19/10 I suppose you could pressurize your sensor and check voltage - Wright (Ca) 11:31:00 02/19/10 Yes, i got the info from the zeitronix website. - hijack 13:18:45 02/19/10 Here's what I found on my zeitronix sensor... - Wright (Ca) 22:23:19 02/19/10 I can't find anything on the AVC-R sensor. - hijack 19:33:45 02/20/10 i was using my avc-r's pressure sensor as a source - Dane (Houston) 22:43:20 02/19/10 That would make sense if the avc-r sensor is a 3.5 bar - Wright (Ca) 22:53:08 02/19/10 well i posted a response yesterday but it didn't appear - hijack 19:20:22 02/21/10
Post a Followup	You cannot reply to this message because you are not logged in.