Subject	Yes, i got the info from the zeitronix website.
Posted by	hijack on February 19, 2010 at 1:18 PM
	This message has been viewed 172 times.
In Reply To	I suppose you could pressurize your sensor and check voltage posted by Wright (Ca) on February 19, 2010 at 11:31 AM
Message	I've found out so far that the avc-r only regulates boost up to 28.5 PSI. Maybe the pressure sensor can go above that but i don't know. The Zeitronix 50PSI MAP can measure boost up to 35.3 PSI. I also found out that all MAP's are pretty much linear. I guess i can run 35 PSI through my air compressor into the apexi sensor and see what voltage i get? Could this damage the sensor?
Follow Ups	Zeitronix with AVC-R MAP? - hijack 07:16:27 02/19/10 Your sensor's voltage/boost characteristics would have to - Wright (Ca) 09:58:41 02/19/10 i found the specs for the zeitronix sensor: - hijack 11:18:24 02/19/10 I suppose you could pressurize your sensor and check voltage - Wright (Ca) 11:31:00 02/19/10 Yes, i got the info from the zeitronix website. - hijack 13:18:45 02/19/10 Here's what I found on my zeitronix sensor... - Wright (Ca) 22:23:19 02/19/10 I can't find anything on the AVC-R sensor. - hijack 19:33:45 02/20/10 i was using my avc-r's pressure sensor as a source - Dane (Houston) 22:43:20 02/19/10 That would make sense if the avc-r sensor is a 3.5 bar - Wright (Ca) 22:53:08 02/19/10 well i posted a response yesterday but it didn't appear - hijack 19:20:22 02/21/10
Post a Followup	You cannot reply to this message because you are not logged in.