Subject	The white lines are meant to line up with the dimples on
Posted by	Audioquest on February 18, 2010 at 8:53 AM
	This message has been viewed 109 times.
In Reply To	The white lines on the timing belt are only for initial>>> posted by ZUL8TR on February 17, 2010 at 12:33 PM
Message	each of the sprocket dimples. The backing plate marks are general reference and never will the sprocket dimples line up exactly with the backing plate marks. The right number of teeth on the belt to sprocket dimple relationship is set by the white lines printed on the belt. Check page EM18 in the manual. The backing plates are not machined accuracy, just stamped parts.
Follow Ups	timing woe's - ZPUHost 20:44:29 02/15/10 Re-check using the coil pack wires going to cylinder - jzack 22:42:20 02/15/10 My car has an underhood OEM sticker showing that >>> - ZUL8TR 06:29:35 02/16/10 2nd. that's the only way my timing light picks it up. (n/m) - KasbeKZ(VA) 08:40:08 02/16/10 The CP connector wire harness is what I use and my - Audioquest 08:58:40 02/16/10 Re: The CP connector wire harness is what I use and my - ZPUHost 17:15:02 02/16/10 Only way to know for sure on the belt is to pull the - jzack 19:09:42 02/16/10 Try the procedure I suggest above B4 anything major (n/m) - ZUL8TR 06:02:34 02/17/10 I would agree. If you are getting strange readings with - Audioquest 10:40:25 02/17/10 The white lines on the timing belt are only for initial>>> - ZUL8TR 12:33:44 02/17/10 The white lines are meant to line up with the dimples on - Audioquest 08:53:13 02/18/10 Of course the number of teeth between the marks on the >>l - ZUL8TR 11:17:13 02/18/10 Yeah, that's all I was getting at. A lot of people try to - Audioquest 11:58:28 02/18/10 Re: Yeah, that's all I was getting at. A lot of people try to - ZPUHost 23:46:07 02/20/10
Post a Followup	You cannot reply to this message because you are not logged in.