Subject	Re-check using the coil pack wires going to cylinder
Posted by	jzack on February 15, 2010 at 10:42 PM
	This message has been viewed 132 times.
In Reply To	timing woe's posted by ZPUHost on February 15, 2010 at 08:44 PM
Message	#1 for the timing light signal. It is possible the t-belt is off a tooth - but I've seen postings on folks having issues trying to set the timing using the PTU loop for the light.
Follow Ups	timing woe's - ZPUHost 20:44:29 02/15/10 Re-check using the coil pack wires going to cylinder - jzack 22:42:20 02/15/10 My car has an underhood OEM sticker showing that >>> - ZUL8TR 06:29:35 02/16/10 2nd. that's the only way my timing light picks it up. (n/m) - KasbeKZ(VA) 08:40:08 02/16/10 The CP connector wire harness is what I use and my - Audioquest 08:58:40 02/16/10 Re: The CP connector wire harness is what I use and my - ZPUHost 17:15:02 02/16/10 Only way to know for sure on the belt is to pull the - jzack 19:09:42 02/16/10 Try the procedure I suggest above B4 anything major (n/m) - ZUL8TR 06:02:34 02/17/10 I would agree. If you are getting strange readings with - Audioquest 10:40:25 02/17/10 The white lines on the timing belt are only for initial>>> - ZUL8TR 12:33:44 02/17/10 The white lines are meant to line up with the dimples on - Audioquest 08:53:13 02/18/10 Of course the number of teeth between the marks on the >>l - ZUL8TR 11:17:13 02/18/10 Yeah, that's all I was getting at. A lot of people try to - Audioquest 11:58:28 02/18/10 Re: Yeah, that's all I was getting at. A lot of people try to - ZPUHost 23:46:07 02/20/10
Post a Followup	You cannot reply to this message because you are not logged in.