Subject	The solenoid starts to open-close (enter in duty cycle mode)
Posted by	Dark Diver on February 15, 2010 at 6:17 PM
	This message has been viewed 161 times.
In Reply To	Re: I also used a nipple from the balance tube and had no issue. posted by Dane (Houston) on February 14, 2010 at 06:02 PM
Message	when boost reaches your target value (or slightly before target boost in order to fine regulate boost and avoid spikes). When boost is far from target value, the solenoid is stuck closed, even under boost like you say.
Follow Ups	Blow another hks 2530 in 300 miles same side - 94ttz32 21:11:33 02/13/10 Re: Blow another hks 2530 in 300 miles same side - Dane (Houston) 22:53:48 02/13/10 Re: Re: Blow another hks 2530 in 300 miles same side - 94ttz32 23:15:23 02/13/10 signal should be between compressor outless and pre throttle - Dane (Houston) 23:55:55 02/13/10 I also used a nipple from the balance tube and had no issue. - Dark Diver 13:15:49 02/14/10 Re: I also used a nipple from the balance tube and had no issue. - Dane (Houston) 18:02:49 02/14/10 The solenoid starts to open-close (enter in duty cycle mode) - Dark Diver 18:17:11 02/15/10 fill out your profile with a list of your mods, it will help - Dane (Houston) 23:59:52 02/13/10 Re: fill out your profile with a list of your mods, it will help - 94ttz32 08:10:39 02/14/10 member services -> profile. (n/m) - KasbeKZ(VA) 10:13:31 02/14/10 Re: member services -> profile. - 94ttz32 11:36:05 02/14/10 cant really see in that picture - Dane (Houston) 12:16:53 02/15/10 Re: cant really see in that picture - 94ttz32 20:01:46 02/16/10 Re: Re: Re: Blow another hks 2530 in 300 miles same side - 94ttz32 11:48:58 02/14/10
Post a Followup	You cannot reply to this message because you are not logged in.