Subject	In your post you said you heard clunking..
Posted by	ZX-infinity (Dallas) on February 07, 2010 at 11:08 AM
	This message has been viewed 72 times.
In Reply To	Re: Did you use aluminum tubing to make the .132" extensions? posted by canyoncarver on February 06, 2010 at 11:37 PM
Message	Is that similar to the description I made about going over big bumps? It would seem like small movements in the arm produce no sound, but large movements do. Again, I haven't the slightest what failed bearings here would sound like.
Follow Ups	Loud popping noise when going over big bumps - ZX-infinity (Dallas) 20:26:51 02/06/10 Are your shocks pretty new? - canyoncarver 22:00:45 02/06/10 Shocks are not new, they were installed at the same time the - ZX-infinity (Dallas) 22:47:56 02/06/10 Did you use aluminum tubing to make the .132" extensions? - ZX-infinity (Dallas) 23:10:31 02/06/10 Re: Did you use aluminum tubing to make the .132" extensions? - canyoncarver 23:37:44 02/06/10 In your post you said you heard clunking.. - ZX-infinity (Dallas) 11:08:53 02/07/10 It wasn't really a bad noise. - canyoncarver 13:13:30 02/07/10
Post a Followup	You cannot reply to this message because you are not logged in.