Subject	no problem...
Posted by	dbotos on February 05, 2010 at 10:27 PM
	This message has been viewed 135 times.
In Reply To	Re: Barry's right... posted by ZkillS on February 05, 2010 at 04:12 PM
Message	from the service manual: "The power steering oil pressure switch is attached to the power steering high-pressure tube and detects the power steering load, sending the load signal to the ECU. The ECU then sends the idle-up signal to the AAC valve." "Rome was not built in a day."
Follow Ups	HELP with this part... picture... - ZkillS 13:43:44 02/05/10 Isn't that where the electrical sensor - Barry(TN) 13:47:56 02/05/10 Re: Isn't that where the electrical sensor - ZkillS 14:57:55 02/05/10 Barry's right... - dbotos 15:33:06 02/05/10 Re: Barry's right... - ZkillS 16:12:12 02/05/10 no problem... - dbotos 22:27:14 02/05/10 You are suppose to transfer that sensor from the old - jzack 08:24:34 02/06/10 Power steering sensor I have one if you need it (n/m) - dream Z (MD) 19:28:45 02/06/10 Ooops pressure switch (n/m) - dream Z (MD) 19:31:16 02/06/10 Re: Power steering sensor I have one if you need it - ZkillS 01:06:22 02/08/10
Post a Followup	You cannot reply to this message because you are not logged in.