Subject	If you grinded the bolt dwon too much then take off the
Posted by	JonnyZ(SoCal) on February 03, 2010 at 7:42 PM
	This message has been viewed 88 times.
In Reply To	Broke a bolt on the valve cover what would you do? posted by wolftg on February 03, 2010 at 07:25 PM
Message	Valve cover and try again, make sure to use the extractor properly! Use a drill that has speed settings, if it goes full speed all the time than it is going to be harder! If you cant get it out and grind it down too much you can drill the bolt all the way down and re-tap the hole! good luck. [IMG]http://i272.photobucket.com/albums/jj176/johnrambo562/gsx.jpg[/IMG]
Follow Ups	Broke a bolt on the valve cover what would you do? - wolftg 19:25:01 02/03/10 If you grinded the bolt dwon too much then take off the - JonnyZ(SoCal) 19:42:59 02/03/10 Re: If you grinded the bolt dwon too much then take off the - wolftg 20:20:36 02/03/10 Fix it right... - ZTurboFan 20:29:56 02/03/10 i really want to just be lazy but a plenum pull sucks! (n/m) - wolftg 20:37:00 02/03/10 True, I hate the plenum pull! (n/m) - JonnyZ(SoCal) 20:49:10 02/03/10 Bah, so be lazy. - ZTurboFan 00:06:38 02/04/10
Post a Followup	You cannot reply to this message because you are not logged in.